Handguns, Rifles & Shotguns > Rifles

$25 DIY weldable AR receiver kit

<< < (2/5) > >>

shooter:
 I do a lot of welding and machine work, and threading for the tube is gonna be a *****,

OnTheFly:

--- Quote from: shooter on June 05, 2014, 10:29:50 AM --- I do a lot of welding and machine work, and threading for the tube is gonna be a *****,

--- End quote ---

I could just imagine if I did it.  The buttstock would be at a 45 degree angle from the rest of the gun.  :laugh:

Fly

bkoenig:
Sounds like it takes a 1 3/16 - 16 tap.  Brownells has them.  I bet you could weld the buffer tube in place, too. 

Edit:  nevermind, the buffer tube is aluminum.

RobertH:
screw welding.... duck tape is there its at.  i'd rather finish an 80% lower.

bkoenig:
Actually, thinking through this some more....why not just buy a mild steel tube of the correct diameter and weld it in place for a buffer tube?  Add an endcap with a threaded hole and it would work with an A2 or A1 stock.

Navigation

[0] Message Index

[#] Next page

[*] Previous page