General Categories > General Firearm Discussion

AR problems

<< < (2/2)

RobertH:
Are you in Lincoln. I have a few.

Mudinyeri:
I have an A2 spring in Omaha.

landon410:
i fixed the retainer pin spring using a spring off a pen. Seems to work, but I screwed up my rear take down pin spring while putting buffer tube back on, but the hole for my rear take down pin detent and spring is so tight I had to use a drill bit to help push the detent pin in and its pretty well stuck in place, so I don't know if it even needs a spring

FarmerRick:

--- Quote from: landon410 on July 02, 2014, 10:49:40 AM ---i fixed the retainer pin spring using a spring off a pen. Seems to work, but I screwed up my rear take down pin spring while putting buffer tube back on, but the hole for my rear take down pin detent and spring is so tight I had to use a drill bit to help push the detent pin in and its pretty well stuck in place, so I don't know if it even needs a spring

--- End quote ---

What kind of lower is this? Polymer?

landon410:
yes it is an ep armory polymer lower

Navigation

[0] Message Index

[*] Previous page