General Categories > General Firearm Discussion

Gunsmith Omaha area

(1/3) > >>

blopp220:
Any one know a decent gunsmith in the Omaha area to cut and thread an AR 10 barrel?

tstuart34:
Send to ADCO

https://www.adcofirearms.com/

OnTheFly:
Not Omaha, but relatively close.  Cylinder & Slide in Fremont http://www.cylinder-slide.com

Fly

Gary:

--- Quote from: OnTheFly on August 08, 2014, 11:04:24 AM ---Not Omaha, but relatively close.  Cylinder & Slide in Fremont http://www.cylinder-slide.com

Fly

--- End quote ---

Second the thumbs up on those folks. 

Chris C:
Scott at American Reaper referred me to these guys earlier this year.  Turn around was about a week and a half and I just UPS'd them the barrel with a return label.  http://www.fcwguns.com/ 

Cylinder & Slide does good work but are most likely back logged something terrible.  Same most likely with Maple Creek Gunsmiths.  Tried to get them to thread a barrel but was told earlier this year 6 month wait minimum. 

Navigation

[0] Message Index

[#] Next page