General Categories > General Firearm Discussion
Best place for carbide bits... update with sort of finished 80% project on pg 2
tstuart34:
They look great Robert! I think i am going to ask for one of these lowers form Santa this year.
How are the uppers and lowers fitting up? much wiggle?
RobertH:
i like the lowers. the lowers were a blem and a bare lower. they have set screws for the bolt release and for the take down pin. i might look around for another blem if i can find them cheap enough. i bought the blem from Schuyler Arms (http://www.schuylerarmsco.com/) and on the arfcom EE. the uppers and lowers fit pretty good. i haven't installed the pins, so i can't say for sure, but they seem like a pretty good fit.
tstuart34:
--- Quote from: RobertH on August 06, 2015, 04:50:36 PM ---i like the lowers. the lowers were a blem and a bare lower. they have set screws for the bolt release and for the take down pin. i might look around for another blem if i can find them cheap enough. i bought the blem from Schuyler Arms (http://www.schuylerarmsco.com/) and on the arfcom EE. the uppers and lowers fit pretty good. i haven't installed the pins, so i can't say for sure, but they seem like a pretty good fit.
--- End quote ---
Let me know if you find some. If I have the cash I would split the shipping with you and rent your jig if your willing!
Sent from my VS985 4G using Tapatalk
RobertH:
--- Quote from: tstuart34 on August 06, 2015, 09:15:14 PM ---Let me know if you find some. If I have the cash I would split the shipping with you and rent your jig if your willing!
Sent from my VS985 4G using Tapatalk
--- End quote ---
ok, will do.
Navigation
[0] Message Index
[*] Previous page
Go to full version