General Categories > General Firearm Discussion

AR Upper Die?

(1/3) > >>

Mudinyeri:
I'm going to put this here in GFD because there's really no better place for it ....  I'm looking to borrow a 1.25" X 18 TPI die for the barrel nut threads on an AR upper.  Anyone have one in Omaha or nearby?  I might have a little goodie or two to reward any helpful NFOA members. ;)

I have an upper that I purchased complete.  I removed the barrel nut and found that the threads needed some chasing/cleaning.

Thanks.

shooter:
 I don't have a die, but I do have a thread file, you can usually work out damage with that

Mudinyeri:

--- Quote from: shooter on February 26, 2015, 07:38:53 PM --- I don't have a die, but I do have a thread file, you can usually work out damage with that


--- End quote ---

Never done that before.  Not sure I'm confident in my ability to avoid mucking things up further.

shooter:
 bring it over, I think I can clean it up

shooter:
 I ordered a die,  should be here Tuesday, I needed one anyway

Navigation

[0] Message Index

[#] Next page