General Categories > General Firearm Discussion

Anyone know a source for steel (angle iron & rectangular tube) near Lincoln?

<< < (4/4)

OnTheFly:

--- Quote from: tstuart34 on October 25, 2015, 09:40:15 AM ---Hehehe I told fly to contact me. Soooo I guess I will have to message him again.

Sent from my VS985 4G using Tapatalk

--- End quote ---

Finally replied with a bunch of random thoughts trying to describe what I'm thinking about.

Fly

Mudinyeri:
I have some scrap laying around.  Tell me what you need.

Of course, you'll have to haul it from Omaha.  ;D

Edit: My PVC stands break down flat.

OnTheFly:

--- Quote from: Mudinyeri on October 26, 2015, 08:06:15 AM ---I have some scrap laying around.  Tell me what you need.

Of course, you'll have to haul it from Omaha.  ;D

Edit: My PVC stands break down flat.

--- End quote ---

Any consistency to your scrap? Is it flat, angled, slotted, etc? Not being the choosy beggar, but figured consistency of assembly will be a factor for me since I'm trying to come up with a generic plan.

Thanks to everyone for their offers to help in various ways.

Fly

Mudinyeri:

--- Quote from: OnTheFly on October 26, 2015, 02:41:53 PM ---Any consistency to your scrap? Is it flat, angled, slotted, etc? Not being the choosy beggar, but figured consistency of assembly will be a factor for me since I'm trying to come up with a generic plan.

Thanks to everyone for their offers to help in various ways.

Fly

--- End quote ---

I have a little bit of this and a little bit of that.  Pretty sure I have quite a bit of 1.25" OD round (might want to keep some of this for myself) in 20' sticks.  I also have (perhaps literally) a ton of angle.  I think most of it is either 1.75" or 2".  Probably some flat bar stock too.

I was thinking of using some of the 1.25" round to make legs for steel target stands and using re-bar for the cross piece.

50cal:
Menards or any electrical supply has unistrut. http://www.unistrut.us/

Navigation

[0] Message Index

[*] Previous page