General Categories > The NFA Corner

rifle length with supressor

<< < (2/3) > >>

tstuart34:
I wouldn't fulll weld it just drill and pin then top off with a tack weld. There is no need to fully weld the cap.

Sent from my VS985 4G using Tapatalk

RobertH:
If you're going to use pure lead rounds, then cleaning is very important.

I wouldn't do it your way, sounds like a hassle, but its your guns.

tstuart34:

--- Quote from: RobertH on November 25, 2015, 09:20:36 PM ---If you're going to use pure lead rounds, then cleaning is very important.

I wouldn't do it your way, sounds like a hassle, but its your guns.

--- End quote ---
Depending on how he does it you could possibly still make it disassemble depending on the design and cleaning schedules .

Sent from my VS985 4G using Tapatalk

shooter:
I don't load 5.56 with lead. so not a problem there. was trying to go for something more like the MP-5SD,

orion:
I've been thinking of going this route the next time I do a SBR too, a AR in 9mm but going to hold off any any decision till after I get my currant suppressor build stamp back.

I figure that suppressed is all I'd shoot it so why not save a $200.

Navigation

[0] Message Index

[#] Next page

[*] Previous page