General Categories > General Firearm Discussion

Tool for Truing receiver on AR15

<< < (2/3) > >>

shooter:
Brownells has a lapping tool to do the face of the receiver, cost looks to be less that someone doing it for you

   http://www.brownells.com/gunsmith-tools-supplies/rifle-tools/receiver-tools/ar-15-m16-upper-receiver-lapping-tool-prod20220.aspx

RobertH:
eh.... i'd suggest just buy another upper and sell that one as blem unit and note its condition.

tstuart34:
Bkoenig does per another thread if I recall correctly

Sent from my VS985 4G using Tapatalk

bkoenig:
I do, but I don't use it much.  I haven't really noticed a difference in accuracy. 

Mudinyeri:

--- Quote from: NENick on December 23, 2015, 04:39:53 PM ---Not sure. Is it not worth doing?

--- End quote ---

If properly torqued, I doubt it's worth doing.  Once your barrel is torqued down, it shouldn't move.  If it doesn't move, it's consistent.  Consistency is the key to accuracy.

Navigation

[0] Message Index

[#] Next page

[*] Previous page