General Categories > Non Gun Stuff
Bumper/farm jack
Les:
High-Lift jacks work well (I have 2) but don't think I'd use it on a bumper. Hydraulic floor jacks are fairly cheap and safer.
on the fritz:
I'm sensing a trend here. LOL. My only concern is getting the front end high enough. The highest floor jack I found went 23". Would that be high enough to drop the trans?
shooter:
having done some mechanic work, most jacks wont lift a car that high. usually you have to jack it up as high as possible then put on stands,
then put a block on the floor jack and lift it higher,,, always be careful of a car that high. use only good quality jack stands
newfalguy101:
Jack it up and block it, then add a block to the jack and jack it higher and block again.
on the fritz:
--- Quote from: newfalguy101 on December 28, 2016, 08:14:58 PM ---Jack it up and block it, then add a block to the jack and jack it higher and block again.
--- End quote ---
That was my plan. Jack it up a little at a time and keep the jack stands moving up.
I come here and always get good advice or confirmation on my plans. All the suggestions here have really helped solidify my plans.
Now, if I could just get someone to volunteer a nice lift for awhile,... LOL.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version