General Categories > General Firearm Discussion

Glock 19/NY1/3.5 Connector

(1/1)

Lorimor:
Well,  it was a good day to work in the man cave so I clamped the G19 in a vice, put the Glock bit in the Dremel and installed the NY1 spring/Glock "-" (3.5) connector in it.  It was a rough 7 minute job. 

I kind of like it so far, but haven't actually fired the combo yet.  Someday I might carry this thing but finding holsters for Glocks is so difficult!  Nobody makes them!   ::)

Dan W:
I don't recall exactly what sucked the worst, but I hated that trigger setup

Lorimor:

--- Quote from: Dan W on February 23, 2017, 08:14:12 PM ---I don't recall exactly what sucked the worst, but I hated that trigger setup

--- End quote ---

All I've got to compare it against is a Gen4 17 which has had nothing done to it other than new sights.  The 19 w/the NY1 feels smoother.  Pull weight is a tad heavier.  Of course, I've done a 0.13 polish job on the 19.  Can't afford the full blown 0.25 polish job. Maybe someday.  :)

And both triggers feel like I'm dealing with a Daisy Red Ryder. :)

Nebfamman:
Deleted

Les:

--- Quote from: CNeal on March 27, 2017, 05:04:10 PM ---Just did a .25 cent trigger job and put in the "-" connector and the NY-1 spring and while I was at it I also replaced the trigger and trigger bar with a gen 4 G17 smooth trigger.
   I couldn't be happier with this set up. After years ( years ago) shooting DA/SA and DAO autoS this was exactly what this gun needed. Really smoothed it out and got rid all that spongy take up.
   I know lots of folks don't like it but this is the only way I'll ever own a GLOCK again. Matter of fact just ordered a BFG G19 and I'll be ordering the trigger parts now so they will be here when the pistol arrives.

--- End quote ---

Navigation

[0] Message Index