< Back to the Main Site

Author Topic: Hornady Seating Die Question...  (Read 3416 times)

Offline ibdone

  • NFOA Full Member
  • **
  • Join Date: Sep 2016
  • Location: Norfolk
  • Posts: 34
Hornady Seating Die Question...
« on: January 13, 2018, 12:17:31 AM »
 I’m getting conflicting information on the ‘Custom Grade’ seating die crimp. Is it tapered or rolled? Hornady.com says nothing valuable, others say one or the other.

CtD says it's both!
https://www.cheaperthandirt.com/…/hornady-38-357-357-max-35…

Any ideas?

Offline shooter

  • NFOA Full Member
  • **
  • Join Date: Aug 2013
  • Location: near Yutan
  • Posts: 1630
Re: Hornady Seating Die Question...
« Reply #1 on: January 13, 2018, 12:38:01 AM »
 Id suggest calling Hornady Monday and asking them,
Was mich nicht umbringt macht mich stärker
Sic semper evello mortem tyrannis
 NRA Endowment member
  Shoot  them in the crotch.  Clint Smith, thunder ranch.  Oct 14, 2016

Offline SemperFiGuy

  • Steel Benefactor
  • *
  • Join Date: Apr 2009
  • Location: Omaha, NE
  • Posts: 2079
  • GG Grampaw Wuz a DamYankee Cavalryman
Re: Hornady Seating Die Question...
« Reply #2 on: January 13, 2018, 10:48:40 AM »
Why not just put an MT case through the die and check it out?
Use magnifying glass and/or micrometer, if needed.


FWIW

sfg
Certified Instructor:  NE CHP & NRA-Rifle, Pistol, Shotgun, Personal Protection Inside/Outside Home, Home Firearm Safety, RTBAV, Metallic Cartridge & Shotshell Reloading.  NRA Chief RSO, IDPA Safety Officer, USPSA Range Officer.  NRA RangeTechTeamAdvisor.  NE Hunter Education (F&B).   Glock Armorer

Offline ibdone

  • NFOA Full Member
  • **
  • Join Date: Sep 2016
  • Location: Norfolk
  • Posts: 34
Re: Hornady Seating Die Question...
« Reply #3 on: January 13, 2018, 02:31:50 PM »
Thanks both for the advice.  I do plan to call Hornady on Monday.  Good idea, will send an empty one through and see what happens....

Offline noylj

  • Forum Member
  • *
  • Join Date: May 2013
  • Posts: 22
Re: Hornady Seating Die Question...
« Reply #4 on: January 15, 2018, 04:08:43 AM »
If the die is for a revolver cartridge (.38 spl, .357 Mag, .41Mag, .44 Spl, .44 Mag, etc), it will be a roll crimp.
If the die is for a semi-auto cartridge (9x19, .40 S&W, .45 Auto), it will be a taper crimp.
Even better, DON'T seat and crimp in one step--separate them.
Get a Redding Profile Crimp die for roll crimp and a Lee Taper Crimp Die (not necessarily the FCD) for taper crimps.