General Categories > The NFA Corner

I've got a question about barrel length and avoiding SBR status

<< < (2/2)

justsomeguy:
Straight from the horses mouth. (So to speak)

http://www.atf.gov/publications/download/p/atf-p-5320-8/atf-p-5320-8-chapter-2.pdf


--- Quote ---The ATF procedure for measuring barrel length is to measure from the closed bolt (or breech-face) to
the furthermost end of the barrel or permanently attached muzzle device. Permanent methods of
attachment include full-fusion gas or electric steel-seam welding, high-temperature (1100°F) silver
soldering, or blind pinning with the pin head welded over. Barrels are measured by inserting a dowel rod
into the barrel until the rod stops against the bolt or breech-face. The rod is then marked at the
furthermost end of the barrel or permanently attached muzzle device, withdrawn from the barrel, and
measured.
--- End quote ---

Navigation

[0] Message Index

[*] Previous page