Ammunition & Hand Loading > Cartridge and Shotshell reloading

Primers

<< < (2/3) > >>

Necede:
Years ago I had a new Performance Center S&W 629. At first it worked fine and then it started taking two or three strikes to set off the primer. I sent it back to the factory and it turned out to be such and such screws, I forget the proper term, were out of adjustment. It has worked fine since the fix.

bkoenig:
Honestly, I would send it back for service.  You paid good money for a high quality firearm and for it to fail to ignite any commercially available primer is unacceptable.  Just my .02.

maanbr:
I used to have a handi rifle in 500sw.  I was using starline cases with the large rifle pocket and had constant light primer strikes.  When I got some winchester cases my problems went away.

Ronvandyn:
I use CCI primers for all my loads, never had a problem.

Ron

SS_N_NE:
CCI seemed to have pretty decent reviews.
I picked up 1000 large pistol recently and was a little disappointed that the shapes vary when you look at them setting in the original tray. So far, they seat OK and look OK but haven't fired any yet.

Navigation

[0] Message Index

[#] Next page

[*] Previous page