NFOA MEMBERS FORUM
Gear & Equipment => Knives and cutting tools => Topic started by: ghknives on November 08, 2009, 08:55:48 AM
-
There are a lot of sharpeners out there. Some work and others don't. With over 20 years experience as a custom knife maker I have come to rely on the guides and stones manufactured by Razor-Edge. They can be contacted at 1-800-541-1458 or www.razoredgesystems.com. The guides clamp to the blade giving you the control needed to form a precise angle at the edge. Their stones are man made and used dry. I know that goes against every thing we have been taught, but trust me, they work great. When loaded with material I just wash them out with a hand brush and dish soap.
-
Sounds very similar to the Lansky sharpening system I just bought. I've always been horrible at sharpening but this system made it easy for me to get a good edge.
-
I was never able to put a serviceable edge on any blade until I purchased a Gatco system. But it is sorta flimsy and the angles can vary due to that.
This razoredge system look very solid. How does it work with spear point blades?
-
I find the Razor-Edge system is a lot faster than the Lansky and works on most blades. Spear points can be a real challenge getting the guide clamped in place. If I can't get a solid bite on the center ridge it won't hold and even then I have to be careful not to jar it
-
I have had really good luck with the Spiderco Kit i picked up at cabelas. It does need frequent cleaning with a scotch pad and some Comet cleaner.
If you know the angle of the edge, it works fantastic. Versus trying to re-edge a blade.
FYI, Gerber knives are sharpened with a uniform 15? angle on each side for a total of 30?. At least my LMF II loves the 30? setting on the spiderco sharpener.
-
What I have found with sharpening is that the best stone for finishing is a 1000-1200 grit stone. There are many out there but no matter the blade a 1200 grit stone will make your blade surgical. As for sharpening in general I use diamond stones.