NFOA MEMBERS FORUM

General Categories => General Firearm Discussion => Topic started by: grumpy old man on April 23, 2014, 04:42:29 PM

Title: suggestions on gunsmith please.
Post by: grumpy old man on April 23, 2014, 04:42:29 PM

I own a Springfield XDM compact 9mm and I am wanting to get the trigger lightened to 1.5 to 2 lbs.  I live in Greenwood, Ne.  Any recommendations would be greatly appreciated.

Title: Re: suggestions on gunsmith please.
Post by: Dan W on April 23, 2014, 07:07:06 PM

That is a very light trigger for a handgun, even more so for a compact intended for concealed carry... you may have a tough time finding a smith that will take that liability on.

Title: Re: suggestions on gunsmith please.
Post by: on the fritz on April 23, 2014, 08:03:10 PM

If you want a direct drop in trigger (DIY), check out Powder River Precision. 

I doubt you could get it that light of a trigger pull, but......... 

Title: Re: suggestions on gunsmith please.
Post by: RLMoeller on April 23, 2014, 08:29:07 PM

How did you come to that target weight? 

The two most well known places for Springfield XD / XDm work are Springer Precision and Powder River Precision (as mentioned above.)

The work order for Springer Precision says:
*Must be above 2.5#
**XDm triggers below 3.25# must have auto take down deactivated

What are your goals and intended use for this gun?