< Back to the Main Site

Author Topic: All Poly Lower?  (Read 945 times)

Offline fesak454

  • NFOA Full Member
  • **
  • Join Date: Dec 2013
  • Posts: 5
All Poly Lower?
« on: December 16, 2013, 12:23:33 PM »

Offline jonm

  • Forum Member
  • *
  • Join Date: Apr 2012
  • Posts: 273
Re: All Poly Lower?
« Reply #1 on: December 16, 2013, 01:40:15 PM »
I bought 3 of them at once then immediately sold them off. The pins were impossible to push out by hand, there were seam lines down the front of the mag well, and I didnt care for the poly controls. I'm sure there are other things I'm forgetting. In the end, I spent an extra $20 and got a normal lower .

Offline fesak454

  • NFOA Full Member
  • **
  • Join Date: Dec 2013
  • Posts: 5
Re: All Poly Lower?
« Reply #2 on: December 16, 2013, 11:33:44 PM »
Good to know, guess I will skip it. thanks!

Offline FarmerRick

  • NFOA Co-Founder
  • *****
  • Join Date: Mar 2008
  • Location: Valley, NE
  • Posts: 3250
  • Antagonist of liberals, anti-hunters & hoplophobes
Re: All Poly Lower?
« Reply #3 on: December 17, 2013, 07:19:38 AM »
If this is going to be your only AR15, I would suggest sticking with an alloy lower. If this is just going to be a range toy, go for it. I have a couple and have not had any problems. Mine were stripped and I used PSA parts kits in them. Have not had any problems yet.
Those who would give up essential Liberty, to purchase a little temporary Safety, deserve neither Liberty nor Safety.