Gunsmith Omaha area

[blopp220]

Any one know a decent gunsmith in the Omaha area to cut and thread an AR 10 barrel?

[tstuart34]

Send to ADCO

https://www.adcofirearms.com/

[OnTheFly]

Not Omaha, but relatively close.  Cylinder & Slide in Fremont http://www.cylinder-slide.com

Fly

[Gary]

Not Omaha, but relatively close.  Cylinder & Slide in Fremont http://www.cylinder-slide.com

Fly

Second the thumbs up on those folks. 

[Chris C]

Scott at American Reaper referred me to these guys earlier this year.  Turn around was about a week and a half and I just UPS'd them the barrel with a return label.  http://www.fcwguns.com/ 

Cylinder & Slide does good work but are most likely back logged something terrible.  Same most likely with Maple Creek Gunsmiths.  Tried to get them to thread a barrel but was told earlier this year 6 month wait minimum. 

[zofoman]

Scott at American Reaper referred me to these guys earlier this year.  Turn around was about a week and a half and I just UPS'd them the barrel with a return label.  http://www.fcwguns.com/ 

Frerking's is a short 20 mile drive straight South of Lincoln.  Quality work.

[shooter]

Im near Yutan, and I can thread them while you wait,

[blopp220]

Shooter, can you also cut the barrel down and recrown?

[shooter]

Shooter, can you also cut the barrel down and recrown?

  sure, very easy.

  But I cant move the gas port

[blopp220]

That is fine don't need it moved. I just im'ed you for details

[FORAY]

I'm also in-need of a gunsmith to install new sights on my M&P Shield any suggestions?

[barmandr]

I'm also in-need of a gunsmith to install new sights on my M&P Shield any suggestions?

Matzen Gunworks in Bellevue.

[FORAY]

Thank you sir.