Best place for carbide bits... update with sort of finished 80% project on pg 2

[tstuart34]

They look great Robert! I think i am going to ask for one of these lowers form Santa this year.

How are the uppers and lowers fitting up? much wiggle?

[RobertH]

i like the lowers.  the lowers were a blem and a bare lower.  they have set screws for the bolt release and for the take down pin.  i might look around for another blem if i can find them cheap enough.  i bought the blem from Schuyler Arms (http://www.schuylerarmsco.com/) and on the arfcom EE.  the uppers and lowers fit pretty good.  i haven't installed the pins, so i can't say for sure, but they seem like a pretty good fit.

[tstuart34]

i like the lowers.  the lowers were a blem and a bare lower.  they have set screws for the bolt release and for the take down pin.  i might look around for another blem if i can find them cheap enough.  i bought the blem from Schuyler Arms (http://www.schuylerarmsco.com/) and on the arfcom EE.  the uppers and lowers fit pretty good.  i haven't installed the pins, so i can't say for sure, but they seem like a pretty good fit.

Let me know if you find some. If I have the cash I would split the shipping with you and rent your jig if your willing!

Sent from my VS985 4G using Tapatalk

[RobertH]

Let me know if you find some. If I have the cash I would split the shipping with you and rent your jig if your willing!

Sent from my VS985 4G using Tapatalk

ok, will do.